Samsung PL-42P3S Owner's Instructions Manual

Also see for PL-42P3S: Owner's instructions

¸ SURROUND buttonPress the hear the Dolby surround effect.˛ MTS buttonPress to choose stereo, mono or Separate Audio Pro-gram (SAP broadcast).◊ AUTO PROG. buttonThe TV automatically cycles through all of the avail-able channels and stores them in memory.± ADD/DEL buttonPress to add or delete channels in the TV’s memory.≠ DNIe buttonActivates DNIe (Digital Natural Image engine).– CAPTION buttonControls the caption decoder.— SET buttonUsed during set up of this Samsung remote control,so that it will work compatibly with other devices(VCR, cable box, DVD)÷ PIP control buttonsSWAP : Exchanges the video signal that is currentlydisplayed on the main screen with thesignal in the PIP window.SIZE : Press to make the PIP window Large, Smallor Double.CH, : Displays the available channels insequence. (These buttons change channelsin the PIP window only).® VCR, DVD control buttonsControls VCR tape or DVD disc functions: Stop,Rewind, Play/Pause, Fast Forward.∑ RESET buttonIf your remote control is not functioning properly, takeout the batteries and press the reset button for about2~3 seconds. Re-insert the batteries and try using theremote control again.13Remote Control ButtonsŒ POWER buttonTurns the PDP on and off.´ ASPECT buttonPress to change the screen size.ˇ Number buttons¨ +100 buttonPress to select channels over 100. For example, to selectchannel 121, press “+100”, then press “2” and “1.”ˆ MUTE buttonPress to mute the PDP sound.Ø VOL (Volume) buttonsUse it to adjust volume.∏ SLEEP buttonPress to select a preset time interval for automatic shutoff.” MENU buttonDisplays the main on-screen menu.’ ENTER buttonConfirms a selection.˝ PIP buttonActivates picture in picture.Ô STILL buttonPress to pause the current screen. LED DisplayWhen you press a button, ‘ ‘ appears along withselected mode (TV, VCR, CATV, DVD or STB) andremaining batteries on LED.Ò P.MODE buttonAdjust the PDP picture by selecting one of the presetfactory settings (or select your personal, customizedpicture settings.)Ú MODE buttonSelects a target device to be controlled by the Samsungremote control (ie., VCR, Cable, DVD players or STB).If you change modes, the new mode is momentarilydisplayed on LED.Æ PRE-CH buttonTunes to the previous channel.ı TV/VIDEO buttonPress to display all of the available video sources(ie., Video, S-Video, Component1, Component2, PC, DVI).˜ CH (Channel) buttonsUse it to switch channels.¯ INFO buttonPress to display information on the PDP screen.˘ EXIT buttonPress to exit the menu.¿ Up/Down Left/Right buttonsControl the cursor in the menu.12Remote ControlInstalling the Batteries in Your Remote Control1 Slide the back coverto open the batterycompartment of theremote control.3Slide the cover back intoplace.2 Install two AAA size batter-ies. Make sure to match the“+” and “-” ends of the bat-teries with the diagraminside the compartment.Remote Control Operation Range.You can use your remote control within a distance of 23 feet and an angle of 30 degreesfrom the left and right sides of the PDP’s remote control receiver.