Samsung PS-42C91HR Owner's Instructions Manual

Contents

English - 47TroubleshootingBefore contacting the Samsung after-sales service, perform the following simple checks.If you cannot solve the problem using the instructions below, note the model and serial number ofthe television and contact your local dealer.No sound or picture Check that the mains lead has been connected to a wall socket. Check that you have pressed the (Power) button (On/Off) on the front panel or press the POWERbutton on the remote control. Check the picture contrast and brightness settings. Check the volume. Check if Internal Mute is set to ON.Normal picture but no sound Check the volume. Check whether the volume MUTE button on the remote control has been pressed.No picture or black and white picture Adjust the colour settings. Check that the broadcast system selected is correct.Sound and picture interference Try to identify the electrical appliance that is affecting the television, then move it further away. Plug the television into a different main socket.Blurred or snowy picture, distorted sound Check the direction, location and connections of your aerial.This interference often occurs due to the use of an indoor aerial.Remote control malfunctions Replace the remote control batteries. Clean the upper edge of the remote control (transmission window). Check that the “+” and “–” ends of the batteries are inserted correctly. Check that the batteries are drained.Screen is black and power indicator light blinks steadily On your computer check; Power, Signal Cable. The TV is using its power management system. Move the computer’s mouse or press any key on the keyboard. On your equipment check (STB, DVD, etc) ; Power, Signal Cable. The TV is using its power management system. Press the Source button on the panel or remote control. Turn the TV off and on.The damaged picture appears in the corner of the screen. If Just Scan is selected in some external devices, the damaged picture may appear in the corner ofthe screen. This symptom is caused by external devices, not TV.How to assemble the Stand-Base (depending on the model)Using the 6 screws for securing the stand base and themonitor, firmly attach the monitor to the stand base.(The exterior of the set may be different than the picture.)In case of installing your TV on the wall,close the cover (1) on the stand-baseconnection part using two screws forhiding.WarningFirmly secure the stand to the TVbefore moving it, as the stand mayfall and could cause serious injury.➢ Two or more people should carrythe TV. Never lay the TV on thefloor because of possible damageto the screen.Always store the TV upright.BN68-01294B,C-00Eng_CIS.indd 47 2007-05-17 ¿ÀÈÄ 5:51:50