Installing the Display on the Wall Attachment PanelEnglish - 11Wall BracketComponentsPlastic Hanger: 4 Screw : 11Screw : 4 Anchor : 11Wall Bracket AssemblyInstallation Notes◆ Contact a technician for installing the wall bracket.◆ Samsung Electronics is not responsible for any damages to the product or harm to customers whenthe installation is done by the customer.◆ This product is for installing on cement walls. The product may not stay in place when installed onplaster or wood.Hinge Accessories➢ Refer to the correct installation guide according to your wall bracket.1 Insert and tighten the Captive Screw inthe direction of the arrow.When done, mount the wall bracket onthe wall.2 Before drilling into the wall, check if the lengthbetween the two locking holes at the back ofthe product is correct.If the length is too short or long, loosen all orsome of the 4 screws on the wall bracket toadjust the length.3 Check the installation diagram and mark the drill points on thewall. Use the 5.0 mm bit to drill holes deeper than 35 mm.Fix each anchor in the corresponding hole.Match each of the brackets and hinge holes to the correspondinganchor holes and insert and tighten the 11 screws .Length between thetwo locking holesCaptive ScrewWall BracketHinge (Right)There are two hinges(left and right). Use thecorrect one.Hinge (Left)1 Left: 1 Right: 1◆ Only use the components and accessories shipped with the product.
