Samsung PS42P3S Owner's Instructions Manual

Also see for PS-63P3H: Quick guide Remote control guide

Contents

14ENGConnecting a Satellite Receiver or DecoderIn order to watch television programmes broadcast via a satellitenetwork, you must connect a satellite receiver to the rear of thePDP. Also, in order to descramble a coded transmission signal, youmust connect a decoder to the rear of the PDP.Using a Coaxial cableConnect a coaxial cable to the:◆ Receiver (or Decoder) output socket.◆ Television aerial input socket.➢ If you wish to connect both a satellite receiver (or decoder)and a VCR, you should connect the:◆ Receiver (or Decoder) to the VCR◆ VCR to the PDPOtherwise, connect the receiver (or decoder) directly to thePDP.Rear of the PDPSatellite receiver/DecoderTo view television channels correctly, a signal must be received bythe set from one of the following sources:◆ An outdoor aerial◆ A cable television network◆ A satellite network1 In the first three cases, connect the aerial or network input cable tothe 75Ω coaxial socket on the rear of the PDP.2 If you are using an indoor aerial, you may need to turn it whentuning your PDP until you obtain a picture that is both sharp andclear.For further details, refer to:◆ “Storing Channels Automatically” on page 20◆ “Storing Channels Manually” on page 22➢ When installing or re-installing your PDP, be sure to use thesupplied coaxial antenna cable. If you connect using a differentcoaxial cable, there is risk of noise or interference to the screenimage. (You must not use another general purpose cable.Use the 3M/5M/7M cable supplied by Samsung.)Connecting to an Aerial or Cable Television NetworkRear of the PDPCable TelevisionNetworkor