Samsung PS43D450A2W Service Manual

Also see for PS43D450A2W: E-manual User manual

Contents

1. Precaution1.2. Servicing PrecautionsWARNING1) First carefully read the “Safety Instruction” in this service manual.When there is a conflict between the service and the safety instructions, follow the safety instruction at all times.2) Any electrolytic capacitor with the wrong polarity will explode.1) The service instructions are printed on the cabinet, and should be followed by any service personnel.2) Make sure to unplug the AC power cord from the power source before starting any repairs.a) Remove or re-install parts or assemblies.b) Disconnect the electric plug or connector, if any.c) Connect the test part in parallel with the electrolytic capacitor.3) Some parts are placed at a higher position than the printed board. Insulated tubes or tapes are used for this purpose.The internal wiring is clamped using buckles to avoid contact with heat emitting parts. These parts are installed backto their original position.4) After the repair, make sure to check if the screws, parts or cables are properly installed. Make sure no damage is causedto the repaired part and its surroundings.5) Check for insulation between the blade of the AC plug and that of any conductive materials (i.e. the metal panel,input terminal, earphone jack, etc).6) Insulation Check Process:Unplug the power cord from the AC source and turn the switch on. Connect the insulating resistance meter (500V) tothe AC plug blade. The insulating resistance between the blade of the AC plug and that of the conductive materialshould be more than 1MΩ.7) Any B+ interlock should not be damaged.If the metal heat sink is not properly installed, no connection to the AC power should be made.8) Make sure the grounding lead of the tester is connected to the chassis ground before connecting to the positive lead.The ground lead of the tester should be removed last.9) Beware of risks of any current leakage coming into contact with the high-capacity capacitor.10) The sharp edges of the metal material may cause physical damage, so protect yourself by wearing gloves during therepair.11) Due to the nature of plasma display panels, partial after-images may appear if a still picture is displayed on the screenfor a long period of time.This is caused by brightness deterioration due to the storage effect of the panel, and to prevent this from happening, werecommend that the brightness and contrast are reduced. (e.g.) Contrast: 25, Brightness: 50Copyright© 1995-2011 SAMSUNG. All rights reserved. 1-3www.freeservicemanuals.info8/6/2016Published in Heiloo Holland