Samsung PS50B550 User Manual

Also see for PS50B550: User manual User manual User manual User manual

Contents

English - 44Problem Possible SolutionOthersPicture is not shown in full screen. Black bars on each side will be shown on HD channels when displaying upscaled SD•(4:3) contents.Black bars on Top & Bottom will be shown on movies that have aspect ratios different•from your TV.Adjust picture size option on your external device or TV to full screen.•Remote control does not work.Replace the remote control batteries with correct polarity (+ -).•Clean the transmission window located on the top of the remote.•Try pointing the remote directly at the TV from 5~6 feet away.•Plasma TV is making humming noise.Plasma TVs typically make a soft humming sound. This is normal. It’s caused by the•electrical charges that are used to create the images on the screen.If the humming sound is loud, you may have set the brightness on the TV too high.•Try setting the brightness lower.You can also have loud humming if the back of your Plasma TV is too close to a wall•or other hard surface. Also try rerouting your connection cables.Improper installation of wall mount can create excessive noise.•Image Retention (Burn In) Issue.To minimize the possibility of screen burn, this unit is equipped with screen burn•reduction technology. Pixel Shift technology enables you to set picture movement up/down (Vertical Line) and side to side (Horizontal Dot).Can not control TV power or volumewith Cable/Sat box remote control.Program the Cable/Set top box remote control to operate the TV.•Refer to Cable/Set top box user manual for SAMSUNG TV code.“Not Supported Mode” message. Check the supported resolution of the TV and adjust the external device's output•resolution accordingly. Refer to resolution settings in this manual.Plastic smell from TV. This smell is normal and will dissipate over time.•TV Signal Strength is unavailable in theSelf Diagnostic Test menu.This function is only available with digital channels with an Antenna (RF/Coax)•connection.TV is tilted to right or left side. Remove the stand base from TV and reassemble.•Can not assemble stand base. Make sure TV is placed on flat surface.•If can not remove screws from TV, please use magnetized screw driver.Channel menu is grey out (unavailable). Channel menu is only available when TV source is selected.•Your settings are lost after 30 minutesor every time TV is turned off.If TV is in the• Store Demo mode, it will reset audio and picture settings every30 minutes.Please change from Store Demo mode to Home Use mode in the Plug & Playprocedure.Press the SOURCE button to select TV mode, go to MENU → Setup → Plug & Play→ ENTERIntermittent loss of audio or video.Check cable connections and reconnect.•Can be caused by using overly rigid or thick cables.•Make sure the cables are flexible enough for long term use.If wall mounting, we recommend using cables with 90 degree connectors.You may see small particles if youlook closely at the edge of the bezelsurrounding the TV screen.This is part of the product’s design and is not a defect.•Some of above pictures and functions are available at specific models only.N