English - 21− Brightness Test: This test checks to see if your room is bright enough for Motion control to workproperly. Select Start using your remote. The test will start and should take only a few seconds.− Camera Angle Test: Start Camera Angle Test Select Start using your remote. Please put yourselfin the rectangle on the screen by adjusting the camera or moving around. If you are not located inthe correct position, the test may not work properly. When done, please spread your hand in thedirection of the camera, and shake it three or four times from side to side.To use the Motion control function, follow these steps:1. To use the Motion control, raise your hand while opening it toward the screen, hold it for a moment andthen wave it 3 – 4 time to the left and right. Motion control starts. If the Motion control starts, the cursoris displayed at the center of the screen and the Motion guide bar size is at the bottom of the screen.2. Control the TV using your hands.✎ Note that the Motion control function closes if your hands go out of the camera range.✎ While using the Motion control, if you use the other device (i.e. remote control, keyboard, etc.),Motion control closes.Controlling the TV with your hands using gestures■ Access Motion Control− Action: Spread your hand in the direction of the camera, and shake it three or four times from sideto side.■ Pointing NavigationMoves the cursor to the position you want.− Action: Spread your hand and guide the cursor to position you want.■ RunSelects an item or executes a command that is indicated by the cursor or is highlighted.− Action: Clench your fi st.■ BackReturn to the previous menu.− Action: Spread your hand and rotate it counter clockwise.■ Channel / Volume ControlChanges the channel or adjust the volume.✎ If you use the Motion control function while watching a channel, the channel / volume controlscreen appears.− Action: Use the Pointing Navigation gesture to move the cursor to the channel or volumecontroller, and then use the Run gesture to adjust the channel or volume.✎ If you use the Run gesture once, it has the same effect as pressing a button on your remote.If you hold the Run gesture, it has the same effect as pressing and holding a button on yourremote.■ ScrollScroll the page in the direction you want. For example, suppose that you want to scroll down.✎ Some applications may not support this function.1. Move the cursor to the bottom of the screen (page scroll zone) using the Pointing Navigationgesture.2. Move the cursor to the centre of the screen using the Pointing Navigation gesture.3. The page will move down.[PE8000-XU]BN68-04062J.indb 21 2012-04-03 5:29:07