INSTALLATION OF THE WATER DISPENSER LINE29INSTALLATION INSTRUCTIONSCheck the amount of water supplied to the ice tray.1) To remove : Set the "Ice Type" switch to the Ice off position.Lift up (①) and pull out (➁) the icemaker bucket in thefreezer.To replace : When replacing the drawer, be sure to press itfirmly into place. If it does not go all the way back, remove itand rotate the drive mechanism 1/4 turn. Then push thedrawer back again.2) Throw away the first few batches of ice to allow the water line to clear.Be sure nothing interferes with the sweep ofthe feeler arm.When the bin fills to the level of the feelerarm, the icemaker will stop producing ice.It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubes willbecome cloudy, taste stale and shrink.3) Important Facts About Your Dispenser :Do not add ice from trays or bags to the stor-age bin. It may not crush or dispense well.Avoid overfilling glass with ice and use of narrow or extra-tall glasses. Backed-up ice canjam the chute or cause the door in the chute to freeze shut. If ice is blocking the chute,poke it through with a wooden spoon.Beverages and foods should not be quick-chilled in the ice storage bin.To keep dispensed ice from missing the glass, put the glass close to, but not touching, thedispenser opening.Some crushed ice may be dispensed even though you selected CUBES. This happensoccasionally when a few cubes accidentally get directed to the crusher.After crushed ice is dispensed, some water may drip from the chute.4) Water Supply to the Icemaker :The icemaker must be connected to a cold water line.5) Start the Icemaker :Set the "Ice Type" to the "Cubed Ice" or "Crushed Ice" position. The icemaker will notbegin to operate until it reachs its operating temperature of -12°C or below. It will thenbegin operation automatically if the "Ice Type" is in the "Cubed Ice" or "Crushed Ice" posi-tion.ICE MAKER• If there is no water supply, turn off the icemaker to save energy.• In lower water pressure conditions, the water valve may turn on up to 3 times to makesure enough water reaches the icemaker.NOTECHECK THE WATER LEVELRotateDriveMechanismFeeler Arm