Setting Up _101 setting uP1. Slip the compression nut through the supplied plastic tubing .2. Tighten the compression nut onto the 1/4” compression fi tting.- If you are using copper tubing, slip the compression nut (not included) and ferrule (not included) oncopper tubing (not included) as shown.- If you are using plastic tubing , insert the molded end of the plastic tubing into the compressionfi tting.3. Tighten the compression nut onto the compression fi tting. Do not over-tighten the compression nut .4. Turn water on and check for any leakage.instALLing tHe wAteR LineConnecting the water line to the Refrigerator.There are several items that you need to purchase to complete this connection. Youmay fi nd these items selling as a kit at your local hardware store.Only connect the water line to a drinkable water source.If you have to repair or disassemble the water line, cut off 1/4“ of the plastic tubing to make sure you get a snug,leak-free connection.1/4” compression nutplastic tubingcopper tubingferruleNeed to purchase1/4” compression nut copper tubingferruleNeed to purchaseFerrule(Not supplied)Copper tubing(Not supplied)Compression fi tting(Supplied)installing the water fi lter.1. Remove the water fi lter cover( 1 )2. Remove the fi xed cap by turning it counter clockwise.Keep the cap in a safe place for later use if you don’tuse a fi lter.3. Remove the water fi lter from the box and put areplacement indicator sticker on the fi lter as shown.Place a sticker on the fi lter that dates six months inthe future. For example, if you install the water fi lter inMarch, put the “SEP” sticker on the fi lter to remind youto replace in September. That way you’ll know when itis time to replace the fi lter. Normally, a fi lter life is about6 months. Sticker(month indicator)1Plastic tubing(Supplied) Compression nut(1/4”) (Supplied)Compression nut(1/4”) (Not supplied)Plastic tubing(Not supplied)