Setting Up _9sEtting uP tHE REFRigERAtoRNow that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions ofthe appliance. By completing the following steps, your Refrigerator should be fully operational.1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and theRefrigerator. Refer to installation instructions in this manual.2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilledand the motor will run smoothly.4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store foodand drinks in the Refrigerator after the temperature is sufficiently cool.REMoVing tHE REFRigERAtoR DooRsIf the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.Disassemble the Refrigerator doors1. With the door opened, remove the Top Table cap( 1 ) with a Flat head screwdriver, and close thedoor.Remove the 3 screws holding down the Top Tableand remove the Top Table( 2 ).tools you will need21Philips screwdriver 10mm Socket Wrench Allen wrench(3/16”)Flat-blade screwdriver PliersCheck the accessory list below.01 sEtting uPWater filter(DA29-00002B)Hex wrench(DA80-00002C)Fastener(DA60-00143B)Compressin fitting(DA62-00305A)Compression nut(DA74-00070B)Clip fitting lock(red)(DA61-04522A)