setting up _0701 SETTING UPCAUTION2. Disconnect one connector ( 3 ) on the right side doorand one connector ( 4 ) on left side door. To removethe water coupler from the hinge, twist and pull it fromthe hinge. Remove the water line ( 5 ) while pressingthe marked part ( 6 ) of the water line coupler.If a red clip is on the coupler, it must beremoved before removing the tube.3. Pull and remove the hinge lever ( 7 ). Remove theground screw ( 8 ) attached to the upper left andright door hinges with a philips screwdriver (+).Remove the upper left and right door hinges ( 9 ).4. Lift the door straight up to remove.5. Remove the screw ( 10 ) attached to the lower leftand right door hinges with a philips screwdriver (+).Remove the 2 hex head bolts ( 11 ) attached tothe lower left and right door hinges with an allenwrench (3/16”). Remove the lower left and rightdoor hinges ( 12 ).CAUTION4563Red Clip(1/4")7 89SlotSlot312REATTACHING THE REFRIGERATOR DOORSTo reattach the fridge doors after you have moved thefridge to its final location, assemble parts in reverse order.1. The Water Line must be fully inserted to the centerof transparent coupler (Type A) or the line(Type B) toprevent water leakage from the dispenser.2. Insert the clip in the install pack and check that itholds the line firmly.DISASSEMBLE THE FREEZER DRAWER1. Take out the upper drawerby lifting it up.2. Remove the tilting pocket( 1 ) by pulling both supportguards ( 2 ) upward at thesame time.3. Take out the lower basket( 3 ) by lifting the basket upfrom the rail system.4. Remove 4 hex head boltsfrom both sides with a socketwrench (10mm).5. Lift up the freezer door fromthe rails.Putting too much food into the freezer drawerscan prevent the freezer from closing completelyand can cause frost build-up.Allen wrench121011Center of Transparent coupler The Guide LinesDispenserclip A (1/4”)(6.35 mm) clip A (1/4”)(6.35 mm)Type A Type BDA68-02488A-09.indb 7 13. 4. 25. �� 2:07