Samsung RFG296HD User Manual

Also see for RFG296HD SERIES: Quick start guide User manual User manual User manual User manual

When moving your refrigeratorTo prevent floor damage, be sure the frontCAUTIONadjusting legs are in the up position(above the floor). Refer to 'Adjusting the doors' in themanual (on page 9).Flat-blade Control Leverscrew driver(-)FLOORINGFor proper installation, you must place this refrigeratoron a level, hard surface that is the same height as therest of the floor. This surface should be strong enoughto support a fully loaded refrigerator, or approximately3591bs (165kg).To protect the finish of the flooring, cut a largesection of the cardboard carton and place it underthe refrigerator where you are working. When movingthe refrigerator, you need to pull and push it straightforwards or back. Do not wiggle it from side to side.ACCESSORIES AND REQUIREDTOOLSThe following accessories are included with yourrefrigerator:Hex wrench FastenerRequired Tools (Not provided)You need the following tools to complete theinstallation of your refrigerator:Philips Flat-blade screw Socket wrenchscrewdriver(+) driver(-) (10mm)Allen wrenchPliers (3/16") (5mm)REMOVING THE REFRIGERATOR DOORSFor some installationsyou need to remove the fridgeand freezer drawers so you can move the refrigerator to itsfinal location. Do not remove the doors/drawer if you don'tneed to. If you do not need to remove the refrigeratordoors, go to Adjusting the Level on page 8. If you need toremove the doors, continue below. Before removing thedoor/drawer, make sure you read the following items:Z_ Disconnect power to the refrigerator beforeWARNINGremoving the door or drawer.o e careful not to drop, damage or scratch thedoor/drawer while removing them.o Be careful not to get injured while removing thedoor/drawer.o Reattach the door/drawer properly to avoid:- Moisture from air leakage.- Uneven door alignment.- Wasting energy due to improper door seal.Disassemble the refrigerator doorsZ_ Be careful not to drop and scratch the doorsWARNINGwhile removing the doors.Disassemble the refrigerator doors= With the door opened, remove the cap top table( 1 ) with a flat-blade screwdriver(-), and close thedoor. Remove 2 screws holding down the coverhinge ( 2 ) and turn it with several wires connected.06 setting upDA68-02488A-09.indb 6 13. 4. 25. 13132:07