22_ setting upDo not use without the molded end (Bulb)B1. T Bcompression fitting.B2. Turn water on and check for any leakage. If youfind water drops or leakage in the connectionareas, turn off the main water supply. Checkthe connections and, if necessary, tighten.3. Flush 1 gallon of water through the filter beforedrinking or using the water from the refrigerator.(Flush approximately 6 minutes.) To flush, pressa large glass or cup against the water dispenserlever. Fill the glass, empty it into the kitchen sinkafter it is filled, and then repeat.4. After you turn on the refrigerator, let the icemaker make ice for 1 to 2 days. Over thatperiod of time, throw out the first 1 or 2 bucketsof ice the freezer makes to ensure all impuritieshave been removed from the water line.Only connect the water line to a drinkablewater source.If you have to repair or disassemble the water line,get a snug, leak-free connection.CAUTIONCOMPLETING THE SET UPNow that you have your new refrigerator installedin place, you are ready to set up and enjoy thefeatures and functions of the appliance.By completing the following steps, your refrigeratorshould be fully operational.1. Make sure your refrigerator is in an appropriatelocation with reasonable clearance between itand the wall. Refer to installation instructions inthis manual.2. Once the refrigerator is plugged in, make surethe interior light comes on when you open thedoors.3. Set the Temperature control to the coldesttemperature and wait for an hour. The freezerwill get slightly chilled and the motor will runsmoothly. Reset the refrigerator and freezer tothe temperatures you want.4. After you plug the refrigerator in, it will take afew hours to reach the appropriate temperature.You can store food and drinks in the refrigeratorafter the temperature is sufficiently cool.