Samsung RS20NCSL Service Manual

Also see for RS20NCSL: Owner's manual and installation Owner's manual and installation User manual and installation instructions

Contents

Samsung RS20NCSL Service Manual Manual pdf 7 page image

3. INSTALLATION71) To protect refrigerator in movementUse padded hand truck as shown. If entrance width isless than 30 , remove doors prior to installation andreattach doors according to procedure below.2) Remove all protective tape and pad in refrigerators.Please adjust the clearance between the doors.3) Set the temperature control to the temperature andwait for an hour.The refrigerator should get slightly chilled and the motorruns smoothly.4) Once the refrigerator temperature is sufficiently coolYou can store food in the refrigerator. After starting therefrigerator, it takes a few hours to reach the appropriatetemperature.Disassemble the refrigerator1) With the door closed, disassemble screw( ) byusing (+) screw driver and then disassemble theupper hinge cover( ).2) Disassemble bolts ( ) and screws ( ) to thecounter-clockwise by using a tool, and take off theupper hinge ( ) along the arrow ( ). Take carewhen you disassemble the door to ensure that it doesnot fall on you.3) Disassemble the door from the lower hinge ( ) bylifting the door ( ).4) Disassemble the lower hinge ( ) from the bracketlower hinge ( ) by lifting the lower hinge ( ) in thedirection of the arrow.Assemble the refrigerator1) Insert the lower hinge ( ) in the bracket lowerhinge ( ).2) Assemble the door ( ) in the lower hinge ( ).3) Insert the upper hinge shaft ( ) into the hole ( ). Afterleveling between the upper hinge hole ( ) and thehole of the refrigerator ( ), assemble bolts ( )and screws ( ) to the clockwise by using a tool.4) Put the front part of the upper hinge cover ( ) on thefront part of the upper hinge ( ) and assemble,starting with the front part of the upper hingecover. Assemble the screw to the clock wise byusing a tool.1)3) 4)3) 4)2) 1) 2)