Samsung RS2534WW Service Manual

Also see for RS2534VQ: User manual Owner's manual and installation guide

Samsung RS2534WW Service Manual Manual pdf 5 page image

52. INSTALLATION1) To protect refrigerator in movementUse padded hand truck as shown. If entrance width isless than 39〃, remove doors prior to installation andreattach doors according to procedure below.2) Remove all protective tape and pad in refrigerators.Connect water lines and power cord. Adjust theclearance between the doors.3) Set the temperature control to the temperature andwait for an hour.The refrigerator should get slightly chilled and the motorruns smoothly.4) Once the refrigerator temperature is sufficiently lowYou can store food in the refrigerator. After starting therefrigerator, it takes a few hours to reach the appropriatetemperature.●● Removing DoorsOpen the freezer and refrigerator doors, andthen take off the front leg cover assembly byturning the three screws counter-clockwise.Remove the screw from clamp disconnect, thewater tube by pressing the coupler, and pullingthe water tube away.With the door closed, remove the upper hingecover using a screwdriver, and then disconnectthe wires. Remove hinge screws and groundscrew counter-clockwise, and take off the upperhinge. Take care removing the door to ensure thatit does not fall on you.Remove the door from the lower hinge bycarefully lifting the door so as not to damage thewater tube. Remove the lower hinge from thelower hinge bracket by lifting the lower hinge.●● Attaching DoorsInsert the lower hinge in the bracket lowerhinge. Attach the freezer door by inserting thehose in the lower side of the door into the hole inthe lower hinge and pulling the hose down.Insert the upper hinge shaft into the hole. Afterleveling between the upper hinge hole and thehole of the cabinet. Reattach hinge screws andscrew in the clockwise direction. Connect thewires. Put the front part of the upper hinge coveron the front part of the upper hinge and reattachfrom the front part of the upper hinge cover first.