26CHECKING THE WATER DISPENSER LINE1) In order to operate the ice maker properly, water pressure of 20 ~125 psi is required.In this range a 170 cc paper cup can be filled in 10 secs.2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.3) If the refrigerator is installed in an area with low water pressure (below 20psi), you should install abooster pump to compensate for the low pressure.4) Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dispenserlever until the water runs from the outlet.NOTEWater line installation kit is available at extra cost from your dealer. The refrigerator manufacturerrecommends using a water supply kit containing copper tubing.Connecting to water supply line- Shut off the main water supply line and turnthe Ice maker to the off position.- Locate the nearest cold drinking water line.- Follow the instructions in the ice makerinstallation kit.- After connecting the water supply with waterfilter, turn on water supply and flush 4 ormore gallons into a bucket to clear the waterfilter1. Cold Water line2. Pipe Clamp.3. Water Line Installation Kit4. Shut Off Valve