English - 35MAINTAINREPLACING THE WATER FILTERReplace the water filter when the waterfilter indicator turns red.The water filter is located on the bottomright side of the refrigerator.To make changing the water filter easier, you maywant to shut off the water supply, and then drainany water remaining in the water line by pressingthe Water button and then pressing a glass againstthe water dispenser pad.1. Turn the water filter 90˚ counter-clockwise.LOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCK2. Pull the water filter out of the filter housing.LOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCK3. Insert a new water filter into the filter housing.LOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCK4. Turn the new water filter 90˚ clockwise.LOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCKUNLOCKLOCKLOCK5. Press and hold the Water button for 3 secondsafter changing the filter to reset the filterindicator.Confirm the indicator turns blue.When you replace the water filter, some watermay leak from the water filter housing.Make sure to wipe up any leakage that mayhave occurred.Removing residual matter from inside thewater supply line after installing a newfilteLOCKWaterIce1. Turn ON the main water supply.2. Press the Water button on the control panel.Place a cup or glass under the water outlet,and then push the cup or glass against thedispenser pad until you hear a "click".3. Flush 3 gallons of water through the filter.(Flush approximately 6 minutes.)This will clean the water supply system andremove air from the lines.4. Additional flushing may be required in somehouseholds.5. Open the refrigerator door and make sure thereare no water leaks coming from the water filter.A newly installed water filter cartridge maycause water to briefly spurt from the waterdispenser.This is the result of air getting into the line.It poses no problem to the operation of therefrigerator.DA68-02981D-00.indb 35 2014. 1. 27. 3:25