Samsung RS25J50 User Manual

Also see for RS25J50: User manual User manual User manual User manual

Contents

Samsung RS25J50 User Manual Manual pdf 15 page image

English - 15SETTING UP1. Unscrew the nut ( 1 ) from the lower hinge untilit reaches the upper end of the bolt ( 2 ).(2) Bolt((2(1) Nut(1) Nut(3) Wrench(3) WrenchWhen you release the nut ( 1 ), make surethat you use the hex wrench provided( 3 ) to loosen the bolt ( 2 ) in a counter-clockwise ( ) direction.You should then be able to unscrew thenut ( 1 ) with your fi ngers.2. Adjust the height difference between the doorsby turning the bolt ( 2 ) clockwise ( ) orcounter clockwise ( ).(2) Bolt(2) Bolt(3) Wrench(3) WrenchWhen you turn clockwise ( ), thedoor will move up.3. After adjusting the doors, turn the nut ( 1 )clockwise ( ) until it reaches the lowerend of the bolt, then tighten the bolt again withthe wrench ( 3 ) to fi x the nut in place ( 1 ).(2) Bolt((2(1) Nut(1) Nut(3) Wrench(3) WrenchIf you do not secure the nut fi rmly, the boltmay release.INSTALLING THE WATERDISPENSER LINEA water dispenser is one of the helpful features onyour new Samsung Refrigerator.To help promote better health, the Samsung waterfi lter removes unwanted particles from your water.However, it does not sterilize or destroymicroorganisms.You may need to purchase a water purifyingsystem to do that.The water line also connects to the ice maker.For the ice maker to operate properly, waterpressure of 20 ~ 125 psi (138 ~ 862 kPa) isrequired.If the refrigerator is installed in an area with lowwater pressure (below 20 psi), you can install abooster pump to compensate for the low pressure.After you have connected the water line, makesure the water storage tank inside the refrigeratoris properly fi lled.To do this, press the water dispenser lever untilwater runs from the water dispenser.Water line installation kits are available atextra cost from your dealer.We recommend using a water supply kitthat contains copper tubing.Connecting to the water supply line1. First, shut off the main water supply line andturn the ice-maker off.The refrigerator should NOT be plugged inat this point.2. Locate the nearest cold water drinking waterline.3. Install the pipe clamp and shut off valve.4. Connect the water line installation kit to theshut off valve.Shut off valveShut off valvePipe clampPipe clampCold water lineCold water lineWater line installation kitWater line installation kitSSEDA Drop In- EN.indd 15SSEDA Drop In- EN.indd 15 2015. 2. 6. 9:392015. 2. 6. 9:39