26INSTALLATION OF THE WATER DISPENSER LINECheck the amount of water supplied to the ice tray.1) To remove : Set the "Ice Type" switch to the Ice off position. Liftup (①) and pull out (➁) the icemaker bucket in the freezer.To replace : When replacing the drawer, be sure to press itfirmly into place. If it does not go all the way back, remove itand rotate the drive mechanism 1/4 turn. Then push the drawerback again.2) Throw away the first few batches of ice to allow the water line toclear.Be sure nothing interferes with the sweep of the feeler arm.When the bin fills to the level of the feeler arm, the icemaker willstop producing ice.It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubeswill become cloudy, taste stale and shrink.3) Important Facts About Your Dispenser :Do not add ice from trays or bags to thestorage bin. It may not crush or dispensewell.Avoid overfilling glass with ice and use ofnarrow or extra-tall glasses. Backed-up icecan jam the chute or cause the door in thechute to freeze shut. If ice is blocking thechute, poke it through with a wooden spoon.Beverages and foods should not be quick-chilled in the ice storage bin.To keep dispensed ice from missing the glass, put the glass close to, but not touching, the dispenseropening.Some crushed ice may be dispensed even though you selected CUBES. This happens occasionallywhen a few cubes accidentally get directed to the crusher.After crushed ice is dispensed, some water may drip from the chute.4) Water Supply to the Icemaker :The icemaker must be connected to a cold water line.5) Start the Icemaker :Set the "Ice Type" to the "Cubed Ice" or "Crushed Ice" position. The icemaker will not begin to oper-ate until it reachs its operating of 10.4°F( -12°C) or below. It will then begin operation automatically ifthe "Ice Type" is in the "Cubed Ice" or "Crushed Ice" position.CHECK THE WATER LEVELRotateDriveMechanismFeeler ArmICE MAKER• If there is no water supply, turn off the icemaker to save energy.• In lower water pressure conditions, the water valve may turn on up to 3 times to make sure enoughwater reaches the icemaker.NOTE