Samsung RS263B Series User Manual

Also see for RS263B Series: Owner's manual and installation Owner's manual & installation Owner's manual and installation Owner's manual and installation

WATERICE282) When you press the test button, the ice cube container isfilled with water from the water supply tap.Check the amount of water (see the illustration below).If the water level is too low,the ice cubes will be small.This is not a problem with the ice makerbut of the water pressure inthe pipe, and occurs frequently.When this problem occurs, contacta service person to check theamount of water supplied.INSTALLATION OF THE WATER DISPENSER LINERemove any residual matter inside the water supply line after installing filter.Check the amount of water supplied to the ice tray.1) Lift up (①) and pull out (➁) the ice maker bucket in the freezer.ICE MAKER1) Turn on the main water supply & shut-off the valve of thewater supply line.2) Run water through the dispenser until the water runs clear(6~7 minutes). This will clean the water supply system andclear air from the lines.3) Additional flushing may be required in some households.4) Open the refrigerator door and check if water leaks aroundthe water filter.• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.• Before reinstalling the water filter, remove the wine shelf (RS264A/RS265B/RS267B/RS267L/RS269L).NOTECHECK THE WATER LEVELTEST BUTTONTOO HIGHOPTIMUMLEVELTOO LOW