17INSTALLATION INSTRUCTIONSINSTALLATION OF THE REFRIGERATORCheck the dimensions of your entrance door to determine whether the refrigerator can pass through it.• Select a location with easy access to the water supply.• Select a location with enough space for the refrigerator.• Select a location which is not exposed to sunlight.• Select a location with level floor.• Before disassembling the freezer door, the water supply line needs to be disconnected.(If not, the water supply line can be damaged.)• See “Separating the water supply line from the refrigerator” on the next page.Checking the Dimensions of your Entrance DoorSelecting the Location for the RefrigeratorHow to assemble the separable door handleAllow clearance to the right, left, back and the top when installing therefrigerator. This has the advantage of reducing power consumption.Do not install the refrigerator where the temperature will go below50°F(10°C).Allow sufficient space to circulate the air in the internal cooling system.• If the refrigerator does not have enough space, the internal cooling systemmay not work correctly.2inches0.1inch2 inchesNOTENOTEDimension(inches)WidthCapacity (Cu. Ft)Model RS275 / RS27726 1/2without HingeCase Height with Hingewith doorDepth without door35 7/868 1/27033 13/1630 1/2- Make sure the “UP” mark on the rearof the handle is facing right side up.- Match the upper and lower HandleLocking Tabs on the doors to thehandles.Fix the handles to the doorsby sliding them down firmly.- Check the installation of the handlesby pulling them.- If the handles are inserted properly,they should not move.