1_ setting up. After adjusting the doors, turn the nut 1 clockwise until it reaches the lower end ofthe bolt, then tighten the bolt again with the wrench to fix the nut in place 1 .If you do not secure the nut firmly, the bolt may release.CHECKing tHE watEr DisPEnsEr LinE (oPtionaL)A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promotebetter health, the Samsung water filter removes unwanted particles from your water. However, it does notsterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normalconditions, a 170 cc paper cup can be filled in 10 seconds.If the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a boosterpump to compensate for the low pressure.Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the waterdispenser lever until the water runs from the water outlet.Water Line installation Kits are included with unit. You can find it in freezer drawer.instaLLing tHE watEr DisPEnsEr LinEParts for water line InstallationConnecting to the water supply lineConnect the water pipe with coupler and tap.1. Close the main water tap.. Connect coupler “A” to the tap. Note:Water line fixerand screws Pipeconnector Water line Filterlock-clip Filter1WrenchboltNutCAUTIONThe water line must be connectedto the cold water pipe.If it is connected to the hotwater pipe, it may cause thefilter to malfunction.WARRANTY INFORMATIONThis water line installation is not covered by therefrigerator or ice maker manufacturer’s warranty.Follow these instructions carefully to minimise therisk of expensive water damage.Note:If the coupler does not fit on the current tap, gothe nearest authorised service dealer and purchasethe right couplers fittings.COUPLER “A”TAP