Samsung RT38 User Manual

Also see for RT20: User manual User manual

Contents

Samsung RT38 User Manual Manual pdf 9 page image

setting up _0901 SETTING UPSpacerSpacerSpacerSpacerRemove paper on spacer and then attachtwo spacers (Gray block) on the backside of refrigerator for better performance.Make sure two spacers fi x like belowimage when you install the refrigerator. Itis improving the refrigerator performance.(Optional)Allow suffi cient space to the right, left,back and top for air circulation.This will help reduce power consumptionand keep your energy bills lower.Do not install the refrigerator where thetemperature will go below 10 °C.Please ensure that appliance can bemoved freely in the event of maintenance& service.When installing, servicing, or cleaningbehind the refrigerator, be sure to pull theunit straight out and push back in straightafter fi nishing. Also, make sure your fl oorsupports the full-load refrigerator.Otherwise, it may cause fl oor damage.Please tie up the extra length of the powercord at the back of the refrigerator so asnot to be touched on the fl oor preventingthe power cord from being crushed by therollers upon relocation.FLOORINGFor proper installation, this refrigerator must beplaced on a level surface of hard material thathas the same height as the rest of the fl ooring.This surface should be strong enough to supporta fully loaded refrigerator (or approximately 100kg). To protect the fl oor fi nish, cut a large sectionof the cardboard carton and place it under therefrigerator where you are working.Pulling or pushing the refrigerator maydamage the fl oor.Moving the refrigerator after installationmay damage the fl oor.CAUTIONCAUTIONBe careful : do not damage the cover legwhile moving the refrigerator. The coverleg protects the wire and hose . If it isdamaged, the refrigerator may also bedamaged. (Optional)Cover LegCover LegLEVELLING THE REFRIGERATORIf the front of the appliance is slightly higher thanthe rear, the door can be opened and closed moreeasily.< Case2 >< Case2 >< Case1 >< Case1 >Case 1) The appliance tilts down to the left.Turn the left adjusting leg in the direction of the•arrow until the appliance is level.Case 2) The appliance tilts down to the right.Turn the right adjusting leg in the direction of•the arrow until the appliance is level.CAUTION