operating _2902 OPERATINGoperating your samsung refrigeratorMAKING ICEAUTO ICE MAKER MODELThe ice maker will produce 8 cubes per cycle - approximately 100~130cubes in a 24-hour period, depending on freezer compartmenttemperature, room temperature, number of door openings and other useconditions.Throw away the first few batches of ice to allow the water line to clear.Be sure nothing interferes with the sweep of the feeler arm.When the bin fills to the level of the feeler arm, the icemaker will stopproducing ice.After the icemaker has been turned on again, there will be a time delaybefore the icemaker resumes operation.It is normal for several cubes to be joined together.If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.So if you don’t want to make ice, press the Ice Off button.TWIST ICE MAKER MODEL1. Pull out the Ice-cube trays.2. Fill trays up to the water level mark(arrow).3. Put the Ice-cube trays back in position. And close the freezer door.4. Once the water has become frozen, turn the dials on the Ice cube trays to empty Ice cubes intothe storage bin.Saving Energy Tips• Install the appliance in a cool, dry room with adequate ventilation.Ensure that it is not exposed to direct sunlight and never put it near a direct source of heat (radiator,for example).• Never block any vents or grilles on the appliance.• Allow warm food to cool down before placing it in the appliance.• Put frozen food in the refrigerator to thaw.You can then use the low temperatures of the frozen products to cool food in the refrigerator.• Do not keep the door of the appliance open for too long when putting food in or taking food out.The shorter time for which the door is open, the less ice will form in the freezer.• Clean the rear of the refrigerator regularly. Dust increases energy consumption.• Do not set temperature colder than necessary.• Ensure sufficient air exhaust at the refrigerator base and at the back wall of the refrigerator. Do notcover air vent openings.• Allow clearance to the right, left, back and top when installing. This will help reduce powerconsumption and keep your energy bills lower.1 2 43