MAKiNg iCE (oPTioNAL)- TWIST ICE MAKERMaking Ice CubesRemove the ice cube tray by pulling it towards you.Fill the tray with water up to the maximum water levelmarked on the rear of the tray.Slide the tray back into the holder, taking care not tospill the water.Wait until the ice cubes are formed.Removing the Ice CubesMake sure that the ice cube storage bin is in placeunder the ice cube tray. If not, slide it into place.Twist one of the levers firmly in the clockwise directionuntil the tray twists slightly.Result : The ice cubes fall into the storage bin.Repeat Step 2 for the other half of the tray, if necessary.Remove the storage bin by:• Lifting it slightly• Pulling it towards you- REMOVABLE ICE TRAYMaking ice cubesRemove the ice cube tray by pulling it towards you.Fill the tray with water up to the maximum waterlevel marked on the rear of the tray.Slide the tray back into the holder,taking care not tospill the water.Removing the ice cubesTo remove ice cubes, hold the tray at its endsand twist gently.Water LevelusiNg wATEr DisPENsEr(oPTioNAL)With the water dispenser, you can obtain chilled water easily without opening the refrigerator door.Lift up and pull out the water tank.• Hold the handgrips on both sides to lift out thewater tank.• Clean the inside of water tank when using it forthe first time.Fill the water tank with water, ensuring that it is in a stable position,allowing for the extended water supply outlet.• Fill with water up to 2.8l. If it is filled higher than this, it may overflow when thelid is closed.• It is impossible to fill the tank with water while it is positioned in the refrigerator.12_ operatingDA99-01697A(0.7)-EN.indd 12 2011.6.8 5:38:38 PMDA99-01697A(0.8)-EN.indd 12 2011.6.9 1:10:0 PM