Samsung Refrigerator User Manual

Also see for Refrigerator: Owner's manual User manual User manual User manual Owner's instructions

Contents

Samsung Refrigerator User Manual Manual pdf 16 page image

16_ setting up4. After connecting the water supply to the waterfilter, turn your main water supply back on andDispense about 3L to clear and prime the waterfilter.INSTALLING THE WATERDISPENSER LINEConnecting the water line to therefrigerator1. Remove the cap from water line on the unit andinsert compression nut to the water line on theunit after disassembling from provided water line.2. Connect both water line from the unit and waterline in the kit3. Tighten the compression nut onto thecompression fitting. Be careful no gap betweentwo items.4. Turn water on and check for any leakage.CHECKING THE WATERDISPENSER LINEA water dispenser is just one of the helpful featureson your new Samsung refrigerator. To help promotebetter health, the Samsung water filter removesunwanted particles from your water. However, itdoes not sterilize or destroy microorganisms. Youwill need to purchase a water purifying system to dothat.In order for the icemaker to operate properly, waterpressure of 138 ~862 kPa is required. Under normalconditions, a 170 cc paper cup can be filled in 10seconds.If the refrigerator is installed in an area with low waterpressure (below 138 kPa), you can install a boosterpump to compensate for the low pressure.Make sure the water storage tank inside therefrigerator is properly fi lled. To do this, press thewater dispenser lever until the water runs from thewater outlet.Water Line installation Kits are included withunit. You can fi nd it in freezer(or fridge) drawer.The new hose-sets supplied with theappliance are to be used and that old hose-sets should not be reused.Parts for water line Installation1 Water line fixerWater line fixerand screwsand screws 2 Pipe connectorPipe connector 3 Water lineWater line4 ClipClip 5 Water FilterWater FilterConnecting to the water supply line1. First, shut off the main water supply line.2. Locate the nearest cold, drinking water line.3. Follow the Water Line Installation Instructions inthe installation kit.CAUTIONThe water line must be connected tothe cold water pipe.If it is connected to the hot water pipe,it may cause the purifier to malfunction.Close MainClose MainWater pipeWater pipeClose MainClose MainWater pipeWater pipeNo gapNo gapRemoveRemovecapcapWater LineWater Linefrom unitfrom unitWater LineWater Linefrom Kitfrom KitNo gapNo gapLoosen aLoosen a