BN68-05357A-01QUICK STARTGUIDEWelcome to your new Smart TV!The following instructions cover assembling, connecting, and setting up your new TV. Makesure you have the accessories listed below.Included in this boxRemote Control One connect and CablesSmart Touch Control Power cord IR extenderBatteries (AAA x 4) RCA Adapter x 2 Component adapterOne connectRemote Control One connect cableAlso included: User manual, 3D active glassesStep 1Attach the TV tothe StandStep 2Connect videodevicesStep 3Insert thebatteries into theremote controlStep 4Power on andstart the initialsetupWarning: Screens can be damagedfrom direct pressure when handledincorrectly. We recommend lifting theTV by the edges, as shown.Step 1 Attach the TV to the Stand1 Open the package, and remove the cushioning.6M4 x L20Secure the stand to the TV using four screws asshown in the diagram.REQUIRED TOOLS: a Phillips head screwdriver and a soft, flat surface larger than the TV(such as the box).2Stand coverScrewsStandM4 x L20 4 piecesM4 x L10 2 piecesx 4 x 2Pull the stand out of the top Styrofoamcushioning, and make the stand face your body,as shown in the illustration. Insert a fingerinto the groove in the middle and pull it up toseparate the cover from the stand.7 To replace the stand cover, fix its exterior andthen the interior into the stand. Press bothsides firmly to make sure that it is completelyassembled.3 Remove the TV from the box. Then, removethe top and bottom pieces of Styrofoam fromthe TV, but keep the screen-protection pieceon. Place the TV down on the the box with thescreen facing down.8 Remove the port cover, and connect the powercord to the One Connect.4HookTilt the stand to put its hook into the groove onthe back of the TV, and push it, giving it a slightturn until it is firmly in place. 9 Replace the port cover.5M4 x L10Secure the bottom of the stand to the TV usingtwo screws.10 Stand the TV up, and remove the Styrofoambumper and the 4 protective pads from thescreen.S9C