Samsung SCC-C4305(P) Owner's Instructions Manual

Also see for SCC-C4205: Owner's instructions

Contents

E146. The requirements for RS485 control is as follows : Signaling Speed: 9600 bps Data Bit : 8 bits Stop Bit : 1 bit Parity Bit : nonePROTOCOL SAMSUNGADDRESS 0TYPE RS-485, HALFBAUD RATE 9600LENS OKEEP VER 1.0ROM VER 1.04. Determine the type of power supply and set the POWERSELECTION switch accordingly. Next, plug the poweradapter into a wall outlet.The requirements for the power adapter for each model areas follows: SCC-C4205(P) : DC12V 600mA SCC-C4305(P) : AC24V 300mADC12V 600mA5. If the camera operates normally, the following screen willbe displayed for 5 seconds and then disappears.131. Connect one end of the BNC cable to the VIDEO OUT.2. Connect the other end of the BNC cable to the VIDEO INof the monitor.3. Plug in the power adapter. Use a "minus" screwdriver toconnect one part of the power adapter, which consists oftwo lines, to the POWER terminal of the camera as follows :REMOTE RS-485 PWR INREMOTE RS-485 POWERVideo terminals on the backof the monitorBNC cablePOWER SELECTION switchunderneath the power adaptePOWER SELECTIONswitch underneath thepower adapteConnecting the Cables