21GGeettttiinngg SSttaarrtteedd20GGeettttiinngg SSttaarrtteedd2. When you wish to switch the phone off, holdthe key down more than two seconds.WARNING!Do not switch the phone on when mobile phone useis prohibited or when it may cause interference ordanger.Note: As with any other radio-transmitting device,do not touch the antenna unnecessarily whenthe phone is switched on. Contact with theantenna affects the call quality and may causethe phone to operate at a higher power levelthan otherwise needed.Your Phone’s ModesStandby ModeStandby is the most basic state of your phone. Thephone goes into Standby mode after you turn it on orwhenever you briefly press the key. When yourphone is in Standby mode, you will typically see thegreeting message and the current date and time. If youenter a phone number, you can press the key todial it or press the OK key to save it in the internalPhonebook.Press the key at any time to return to Standbymode. Be careful; if you are on a call when you pressthe key, the call disconnects and the phonereturns to Standby mode.Low Battery IndicatorYou can easily tell if your battery needs to berecharged by checking the Battery Status icon ( ) atthe upper-right corner of your phone’s display. Thepresence of all three bars indicates a full charge, twobars indicates a smaller charge, and one bar indicatesan even smaller charge.When the battery charge level becomes low, thebattery sensor blinks an empty Battery Status icon( ) and sounds a warning tone. If the battery levelbecomes too low, the phone automatically turns off.When this happens, you lose whatever you are doingand your phone call cuts off. Watch the Battery Statusicon and make sure that your battery is adequatelycharged.Switching the Phone On or Off1. Press and hold the key until the power-onimage displays to switch the phone on.The service light on the phone flashes and an alertsounds. When the system locates services, thegreeting message displays along with the date andtime. You can now place and receive calls.If the phone is out of service, the No Service icon( ) appears on the display. In this case, youcannot make and receive calls. You can try againlater when service is available.