50ContactsUp to 500 entries can be stored in Contacts. Each entry can have up to fiveassociated phone numbers and an e-mail address. Each phone number can be up to32 digits in length, including 2-Sec or Wait pauses (see “Manual PauseCalling” on page 23 for more information), and associated names can be up to 32characters in length. You can assign the Speed Call numbers of your choice for eachentry. You can also mark your Contacts list as Restricted to prevent unauthorizedviewing. (See “Restriction” on page 155 for more information).Tip: Speed Call One-Touch Dialing, Two-Touch Dialing, and Three-Touch Dialing allow you to callnumbers stored in Contacts faster.Open Contacts1. In standby mode, press the Menu key ( ), then press forContacts. The following options appear in the display:• Find — Find a phone number By Name.Tip: You can also access the Find option from standby mode, by pressing the Contacts (Up) navigation key.• Add New Entry — Add a number or e-mail address to your Contacts.• Speed Dial — Assign a Contacts entry to a Speed Dial number. (See“Speed Dial” on page 59 for more information.)• Group — Review, send messages to, add Contacts to, or rename four out ofyour five groups. (See “Contacts Groups” on page 61 for moreinformation.)• Memory Info — Display used and available memory for Contacts entries.Tip: To launch the Contacts menu using a voice command — In standby mode, press and hold untilthe phone prompts, “Say a command.” Say “Go to Contacts” into the microphone.2. Use the navigation keys to highlight the option of your choice, and pressthe key.Tip: You can also press the keypad number key that corresponds to the menu option number.@ ))OK
