ENGLISH65CheckingTroubleshooting✤ If you run into any problem using the camcorder, use the following table to troubleshoot the problem.✤ If these instructions do not allow you to solve the problem, take a note of: The model and serial number marked on the bottom of the camcorder. Your warranty, if applicable.✤ Then contact your nearest Samsung authorized service center.Explanation/Solution Check the battery pack (see page 19) or the AC power adapter.(see page 18) Check the POWER, set it to CAMERA. You have reached the end of the cassette. Check the record protection tab on the cassette. (see page 22) You have left the camcorder set to STANDBY for more than5 minutes without using it. (see page 24) The battery pack is fully used up. (see page 21) The atmospheric temperature is too low. (see page 21) The battery pack has not been charged fully. (see page 19) The battery pack is completely dead, and cannot be recharged.Use another battery pack. The battery pack is fully used up. A mechanical fault might have occurred. (see page 64) The lithium battery is not installed or is fully used up.(see page 17) The video heads might be dirty. (see page 62) A mechanical fault might have occurred. (see page 64)SymptomYou cannot switch thecamcorder on.Start/Stop does not operatewhile shooting.The camcorder goes offautomatically.The battery pack is quicklyexhausted.You cannot eject the cas-sette from the compartment.The DATE/TIME indicatorflashes more than 2 timeswhen you set the camcorderto CAMERA.The playback picture is poor.You cannot operate anyfunctions on the camcorder.00732M SCL901 SEA (46-71) 12/26/03 10:46 AM Page 65