Samsung SGH-E760 Service Manual

Also see for SGH-E760: User guide User manual

SAMSUNG Proprietary-Contents may change without noticeCircuit Description2-2This Document can not be used without Samsung's authorization2-2. Baseband Circuit description of SGH-E7602-2-1.. PCF5603 (U405)― Power ManagementEight low-dropout regulators designed specifically for GSM applications power the terminal and help ensure optimalsystem performance and long battery life. A programmable boost converter provides support for 1.8V, 3.0V SIMs,while a self-resetting, electronically fused switch supplies power to external accessories.Ancillary support functions, such as RTC module and High Voltage Charge pump, Clock generator, aid in reducingboth board area and system complexity.I2C BUS serial interface provides access to control and configuration registers. This interface gives a microprocessorfull control of the PCF50603 and enables system designers to maximize both standby and talk times.Supervisory functions. including a reset generator, an input voltage monitor, and a temperature sensor, support reliablesystem design. These functions work together to ensure proper system behavior during start-up or in the event of afault condition(low microprocessor voltage, insufficient battery energy, or excessive die temperature).― Backlight Brightness ModulatorThe Backlight Brightness Modulator (BBM) contains a programmable Pulse-width modulator (PWM) and FET tomodulate the intensity of a series of LED’ s or to control a DC/DC converter that drives LCD backlight.― Clock GeneratorThe Clock Generator (CG) generates all clocks for internal and external usage. The 32.768 kHz crystal oscillatorprovides an accurate low clock frequency for the PCF50603 and other circuitry.2-2-2. LCD ConnectorLCD is consisted of main MAIN LCD, SUB LCDChip select signals in the U305, LCD_CS, can enable LCD. BACKLIGHT signal enables white LED of main LCD. Thesesignal is from U400.16-bit data lines(LD(0)~LD(15)) transfers data and commands to LCD. Data and commands use "RS" signal. If this signalis high, Inputs to LCD are commands. If it is low, Inputs to LCD are data. The signal which informs the input or outputstate to LCD, is required. But this system is not necessary this signal. So "L_WR" signal is used to write data orcommands to LCD. Power signals for LCD are "VDD_IO_HIGH".2-2-3. KeyThis is consisted of key interface pins KEY_ROW(0:4) and KEY_COL(0:4) in PCF5213EL1. These signals compose thematrix. Result of matrix informs the key status to key interface in the PCF5213EL1. Power on/off key is seperated fromthe matrix. So power on/off signal is connected with PCF50603 to enable PCF50603. Key LED is consisted of six whiteLEDs for sub key and eight white LEDs for main key.Main and Sub key LED use the 3.3V LDO for a supply voltage. KEY_LED_ON signal enables eight white LED.