102danger. When connecting the phone or any accessory to another device, read itsuser's guide for detailed safety instructions. Do not connect incompatible products.As with other mobile radio transmitting equipment, users are advised that for thesatisfactory operation of the equipment and for the safety of personnel, it isrecommended that the equipment should only be used in the normal operatingposition (held to your ear with the antenna pointing over your shoulder if you are usingan external antenna).Using Your Phone Near Other Electronic DevicesMost modern electronic equipment is shielded from radio frequency (RF) signals.However, certain electronic equipment may not be shielded against the RF signalsfrom your wireless phone. Consult the manufacturer to discuss alternatives.PacemakersPacemaker manufacturers recommend that a minimum distance of 15 cm (6 inches)be maintained between a wireless phone and a pacemaker to avoid potentialinterference with the pacemaker.These recommendations are consistent with the independent research andrecommendations of Wireless Technology Research.Persons with pacemakers:• should always keep the phone more than 15 cm (6 inches) from their pacemakerwhen the phone is switched on.• should not carry the phone in a breast pocket.• should use the ear opposite the pacemaker to minimize potential interference.If you have any reason to suspect that interference is taking place, switch your phoneoff immediately.Other Medical DevicesIf you use any other personal medical devices, consult the manufacturer of yourdevice to determine if it is adequately shielded from external RF energy. Yourphysician may be able to assist you in obtaining this information. Switch your phoneoff in health care facilities when any regulations posted in these areas instruct you todo so. Hospitals or health care facilities may be using equipment that could besensitive to external RF energy.VehiclesRF signals may affect improperly installed or inadequately shielded electronic systemsin motor vehicles. Check with the manufacturer or its representative regarding your