012Connecting to a Power Source SLB-10A rechargeable battery SpecificationModel SLB-10AType Lithium lonCapacity 1050mAhVoltage 3.7VC harging time Approximately 180 MinutesYou should use the rechargeable battery SLB-10A supplied with thecamera. Be sure to charge the battery before using the camera. Number of images and battery life: Using the SLB-10ABattery life /Number of images ConditionsStill image Approx. 150 MIN /Approx. 300 shotsUsing the fully charged battery, Automode, 10M image size, Fine imagequality, Shot to shot interval: 30Sec.Changing the zoom position betweenthe Wide and the Tele after every shot.Using the flash on every second shot.Using the camera for 5 minutes andthen powering it off for 1 minute.Movie Approx. 120 MINUsing the fully charged battery640x480 image size30fps frame rateÄ These figures are measured under Samsung’s standard conditionsand shooting conditions and may vary depending on the user’smethods.Important information about battery usage. When camera is not in use, turn off the power. Please remove the battery if the camera will not be usedfor long periods. Batteries can lose power over time and areprone to leaking if kept inside the camera. Low temperatures (below 0°C) can affect the performance ofthe battery and you may experience reduced battery life. Batteries will usually recover at normal temperatures. During extended use of the camera, the camera body maybecome warm. This is perfectly normal. Connecting the AC adapter with the USB cable can be used as anAC cable, and you can charge the rechargeable battery with theAC cable.- Using an AC cable: Connect the AC adapter to the USBcable. It can be used as a powercable.- Using a USB cable: Remove the AC adapter.You can download stored imagesto your PC (p.91) or supply thepower to your camera through theUSB cable.