095FAQÊ When the DirectX 9.0c or later is not installedà Install the DirectX 9.0c or later1) Insert the CD provided with the camera2) Run the windows explorer and select the [CD-ROM drive:\DirectX] folder and click the DXSETUP.exe file.The DirectX will be installed.Visit the Microsoft website for downloading the DirectX.Ê If a PC connected with the camera stops responding whileWindows is starting.à In this case, disconnect the PC and the camera and Windowswill start. If the problem happens continuously, set the LegacyUSB Support to disable and re-start the PC. The Legacy USBSupport is in the BIOS setup menu. (The BIOS setup menudiffers from the PC manufacturers and some BIOS menus don’t have Legacy USB Support) If you can’t change the menu byyourself, contact to the PC manufacturer or BIOS manufacturer.Ê NOTE:This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation.This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occurin a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determinedby turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the distance between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from thatto which the receiver is connected.– Consult the dealer or an experienced radio / TV technician for help.Ê CAUTION:Changes or modifications not expressly approved by the manufacturerresponsible for compliance could void the user’s authority to operatethe equipment.FCC notice