12Battery LifeThe battery life has a 6 months warranty after purchase.As time goes by, there will be a reduction in the battery spower. When battery s power capacity is reduced byhalf, purchase a new battery and replace it.How to use the battery?Charge the battery for approximately 24hours before using.Always remove the battery from the remoteset, when you are not using the remote setfor an extended period.Charge the battery until you see .nstallation (Continue)n the batteryer.Place the battery asshown in the picture.2ng the battery to the remote setRearrange the lineby setting thebattery as shown inthe picture.3 Close thebattery cover.4To turn on the power : Press and hold the button for more than 2seconds until you begin to hear the beeping sound.If it does not turn on when you press the button, then you probablyneed to recharge the remote set. It should then turn on automatically.Please recharge the battery for 24 hours before using it.If you do not charge the battery for at least 6 hours, then in other protect it,the battery must be fully charged or it will stop operating.To turn off power : Press and hold the button for more than 3 secondsuntil you hear the beeping sound.If you hear a error sound when you turn on the power, register the remoteset.(Refer to page 39)To turn on / off the powerPreparation &Installationfi) 2004.2.25 9:11 AM ˘ ` 11 TWIN1 HyperLaserG3