62 2C. SettingsVibrateTo set your device to vibrate for incoming calls and silentfor notifications: Press the volume button down in standby modeuntil you see on the screen.To set your device to always vibrate for incoming calls:1. Press > and tap > Sound &display.2. Tap Phone vibrate. (If you have already checked theoption, tapping it again deselects the option.)To set your device to vibrate while using the dialpad andmaking onscreen selections:1. Press > and tap > Sound &display.2. Tap Haptic feedback. (If you have already checkedthe option, tapping it again deselects the option.)Silence AllThe Silence All option allows you to mute all soundswithout turning your device off (except for Mediavolume).To activate Silence All: Press and hold the volume button down in standbymode until you see on the screen.To deactivate Silence All: Press the volume button up repeatedly to select avolume level.To set your device to silent mode:1. Press > and tap > Sound &display.Note: By default, the Use incoming call volume fornotifications field is active, in this case, the Notificationslider is not accessible until it is disabled.Tip: You can adjust the ringer volume in standby mode (orthe earpiece volume during a call) by using the volumebutton on the left side of your device.SPH-M920.book Page 62 Friday, October 8, 2010 2:17 PM
