1. Remove the two screws at the back of the top cover.2. Remove the top cover by lifting the back up about 2 inchesand then sliding it forward.3. Remove the small plug button on the left side of the doortop cap.4. Remove the three screws on the upper hinge (right side ).Remove the hinge .5. Remove the three screws at the left hinge location on thetop plate .6. Remove the screw in the middle of the top plate and removethe top plate .7. Lift the door up and off the bottom hinge (right side ).8. Tilt the refrigerator cabinet back to remove the right levelingleg.9. Romove the secrews on the bottom hinge (right side )and theleft leveling leg. Move the bottom hinge to the left side andsecure it with the screws and leveling leg.IMPORTANT:The left leg has a spacer that must be movedto the right side leveling leg when the door swing is reversed.10. Screw the right leveling leg ,with the spacer in place,backin place on the right side.11. Position the door on the left bottom hinge .with themagnetic gasket holding the door in place replace the topplateand screws.12. Make sure the door is aligned with the refrigeratorcabinet before continuing .13. Secure the top hinge with screws.14. Slide the top cover back in place and replace the tow screws.15. Put the plug button in the hole on the right side of the door top cap.DOOR REVERSALTop cover/ cubierta por cimaLeft hinge location/ colocacion izquierda de goznePlug button/ taco boton Door top cap/ tapapor cimade puertaSpacer/ anillo de espaciarLevelinglegs/ pie de nivelacionUpper hinge/ gozne superiorTop plate/ lamina porcimaBottom hinge/ gozne inferior6