Other Information_il_i_i_iii_iii_i_ii_iii!!i_iii_iiiiii!iHi!iiiii!iii!_iii!_i_i!i}iii_iii_iiiiiii!_ii@i_iiiiii!iiii_iHi!Hi:_i@_ii_!_i_i_i_i_iiii_i!!_!_iiPlasma TV is making humming noise. • Plasma TVs typically make a soft humming sound. This b normal. It'scaused by the ebctrbal chargesthat are used to create the images on the screen.• If the humming sound b loud, you may have set the bnghtness on the TVtoo high. Trysetting thebrightness lower.• You can also have loud humming if the back of your Plasma TV is too close to a wall or other hardsurface. Also try rerouting your connection cables.• Improper installation of wall mount can create excessive nobe.Image Retention (Burn In) bsue. • To minimize the possiUlity of screen burn, this unit b equipped with screen burn reduction technology.Pixel Shift technology enables you to set picture movement up/down (Vertical Line) and side to side(Horizontal Dot).The cable/set top box remote control • Program the Cable/Set remote control to operate the T_ Refer to the Cable/Set user manual for thedoesn't turn the TV on or off, or adjust the SAMSUNG TV code.volume.Caption on TV menu is greyed out, • Caption can not be selected in the TV menu when connected via HDMI or Component (p. 24).• Caption must be activated on the external device (p. 23).A "Mode Not Supported" message • Check the supported resolution of the T_, and adjust the external device's output resolutionappears, accordingly. Referto the resolution settings on page 9 of this manual.There is a plastic smell from the T_ • This smell is normal and will dissipate over time.The TV Signal Information is unavailabb • This function is only availablewith digital channels from an Antenna / RF/Coax connection (p. 26).in the Self Diagnostic Test menu.The TV is tilted to the side. • Remove the base stand from the TV and reassemble it.The channel menu is greyed out • The Channel menu is only availablewhen the TV source is selected.(unavailable).Your settings are lost after 30 minutes or • If the TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes. Changeevery time the TV is turned off. the settings from Store Dereo mode to Home Use mode in the Plug & Play procedure. Press theSOURCE button to select TV mode, and go to MENU _ Setup _ Plug & Play _ ENTER _ (p. 8).You have intermittent loss of audio or • Check the cable connections and reconnect them.video. • Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables areflexible enough for long term use. If mounting the TV to a wall, we recommend using cables with 90degree connectors.You see small particles when you look • This is part of the product's design and is not a defect.closely at the edge of the frame of the T_The PIP menu is not availabb. • PIP functionality is only availablewhen you are using a HDMI, PC or Component source.POP (TV's internal banner ad) appears on • Select Home Use under Plug & Play mode. For details, refer to Plug & Play Feature (p. 8).the screen.Some of above pictures and functions are available at specific models only.0 English