Samsung SyncMaster 320 TFT Owner's Instructions Manual

Contents

5InstallationBefore connecting the LCD monitor to your computer, make sure that your computersupports the video mode supported by the LCD monitor. If the video mode, at the timeof installation, is not one supported by the LCD monitor, the LCD monitor may not dis-play the image as it is intended.Connecting Your LCD Monitor1. Be sure that the power switches of both the Computer and the LCD monitor are OFF.2. If you are using a Macintosh computer, connect the other end of the signal cableto a Macintosh adapter. (The adapter is not included with your monitor. Contactyour dealer for more information.) If you are using a standard PC and graphicsboard, skip to step 5.3. Follow the instructions included with your Macintosh-to-PC adapter to set theconfigurations on your adapter, if necessory.4. Connect the signal cable to the video port on the back of your computer.This port might be directly attached to your computer, or it might be part of a videoboard, video card, or graphics card.5. Connect the power cable for the LCD monitor to the back of your monitor.6. Follow the directions that came with your sound card or your computer to connectthe monitor’s speakers and microphone.7. Plug the computer and monitor power cables into a nearby outlet.8. Turn your computer and monitor on.If your monitor displays an image, you have successfully installed the monitor.If the monitor does not display an image, check all the connections and follow thetroubleshooting guide beginning on page 15.9. Your LCD monitor is now ready to use, but to get the best image on the LCD monitor, most of the LCD monitor parameters must be fine tuned to work with the videoadapter you are using. The following sections will guide you through the step-by-step procedures for adjusting the parameters for your specific needs.Your LCD monitor uses an On-Screen Display (OSD) which gives you a convenient way to finetune the quality of the screen image. Six control buttons on the front panel of the LCD monitorare used to operate the OSD menu.320+520-E 7/21/98 11:34 AM Page 5