Samsung SyncMaster 400TS-3 User Manuals

Also see for SyncMaster 460TSN: Brochure & specs User manual User manual

Contents

z Natural3) Video Wall (Screen divider)- The screen can be divided into.You can select a number of screens with a different layout when dividing.z Select a mode from Screen divider.z Select a display from Display Selection.z The place will be set up by pressing a number in the selected mode.z The maximum number of monitors that can be arranged: Horizontal X Vertical = 100z Up to 15 monitors can be arranged in a row. The maximum value for Horizontal is 6 if Vertical is set to 15while the maximum value for Vertical is 6 if Horizontal is set to 15.4) Viewing Screen Splits- You can view and change the layout of screens using the Screen Divider settings.The range of the Screen Divider setting may differ depending on the model.You may not operate this function in MagicInfo.The Input source of TV works only on TV model.The Maintenance Control function is available only for the displays where the power status is ON.Troubleshooting1. The display you wish to control does not appear on the System Info Grid- Check if the entered IP address is correct and check the connection status of the Ethernet cable.- Check the displays to see if any of the other displays connected have the same ID. If more than one displayshave the same ID, those displays are not properly detected by the program due to data conflict.- For monitors that support a Set ID between 0 to 99, you have to set the Set ID to a value between 0 and 99.Note : Check if the Set ID of the monitor is a value between 0 and 99 (set the value using the Displaymenu).2. The display you wish to control does not appear on the other Control Info Grids- Check to see if the display power is ON. (You can check this in System Info Grid)- Check if you can change the input source of the display.3. The dialogue box appears repeatedly.- Check to see if the display you wish to control is selected.4. Both On Timer and Off Timer have been set but different time is showing.- Apply current time to synchronize the display clocks.5. The remote may not function properly when you turn off the remote Function, disconnect the Ethernet cable, orexit the program in an Irregular manner. Rerun the program and turn the remote function again to Restore normalfunctions. This program may malfunction due to problems in communication circuits or interference from electronicappliances nearby.Settings Value Display In Multiple Display ModeWhen there are more than one displays connected, the settings values are displayed as follows.1. No selection: Displays the Factory Default Value.