English - 51Problem Possible SolutionThe picture appears distorted in thecorner of the screen.If Screen Fit When is selected with some external devices, the picture mayappear distorted in the corner of the screen. This symptom is caused by theexternal devices, not TV.The ‘Resets all settings to the defaultvalues.’ message appears.This appears when you press and hold the EXIT button for a while. Theproduct settings are reset to the factory defaults.This TFT LED panel uses a panel consisting of sub pixels (6 220 800) which require sophisticated technology to produce.However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of theproduct.Installing the StandPreset: Place the Guide Stand and Cover Neck onto the stand and fasten it using thescrews.1. Attach your LED TV to the stand.Two or more people should carry the TV.Make sure to distinguish between the front and back of the stand when assemblingthem.To make sure the TV is installed on the stand at a proper level, do not apply excessdownward pressure to the upper left of right sides of the TV.2. Fasten screws at position 1 and then fasten screws at position 2.Stand the product up and fasten the screws. If you fasten the screws with the LED TVplaced down, it may lean to one side.The stand is installed for models with the screen size of 55 inch and above.Disconnecting the Stand1. Remove screws from the back of the TV.2. Separate the stand from the TV.Two or more people should carry the TV.3. Cover the bottom hole with the cover.N¦NNNNNN¦N12FrontBack
