English - 9Connecting Cable TVTo connect to a cable TV system, follow the instructions below.Cable without a Cable BoxPlug the incoming cable into the ANT IN terminal on the back of the TV.Because this TV is cable-ready, you do not need a cable box to view unscrambled cablechannels.Connecting to a Cable Box that Descrambles All Channels1. Find the cable that is connected to the ANT OUT terminal on your cable box.This terminal might be labeled ‘ANT OUT’, ‘VHF OUT’ or simply, ‘OUT’.2. Connect the other end of this cable to the ANT IN terminal on the back of the TV.Connecting to a Cable Box that Descrambles Some ChannelsIf your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)1. Find and disconnect the cable that is connected to the ANT IN terminal on your cable box.This terminal might be labeled ‘ANT IN’, ‘VHF IN’ or simply, ‘IN’.2. Connect this cable to a two-way splitter.. Connect an RF cable between the OUTPUT terminal on the splitter and the IN terminal on the cable box.4. Connect an RF cable between the ANT OUT terminal on the cable box and the B–IN terminal on the RF(A/B) switch.. Connect another cable between the other OUT terminal on the splitter and the A–IN terminal on the RF (A/B) switch.6. Connect the last RF cable between the OUT terminal on the RF (A/B) switch and the ANT IN terminal on the rear of the TV.After you have made this connection, set the A/B switch to the ‘A’ position for normal viewing. Set the A/B switch to the ‘B’position to view scrambled channels. (When you set the A/B switch to ‘B’, you will need to tune your TV to the cable box’soutput channel, which is usually channel 3 or 4.)¦NNNANT INANT IN ANT OUTANT INSplitterCable BoxIncoming cableTV RearANT INRF (A/B) Switch
