Samsung UN55B6000 User Manual

Also see for UN32B6000 - 32" LCD TV: Manual User manual User manual User manual Safety instructions

Problem Possible SolutionImage is not stable and mayappear to vibrate when you havea computer connected to the PCinput.Image is not centered on thescreen.The picture appears distorted in thecorner of the screen.The 'Resets all settings to thedefault values.' message appears.%If the setting is not correct, use your computer utility program to change the displaysettings.Your TV supports multiscan display functions within the following frequency domain:- Horizontal frequency (KHz): 30-_60- Vertical frequency (Hz): 60~75- PC Maximum refresh rate (at 60 Hz): 1920 x 1080Adjust the horizontal and vertical position.The screen position must be adjusted on the output source (i.e. STB) with a digital signal.If Screen Fit is selected with some external devices, the picture may appear distorted inthe corner of the screen. This symptom is caused by the external devices, not TV.This appears when you press and hold the EXIT button for a while. The )roduct settingsare reset to the factory defaults.This TFT LED panel uses a panel consisting of sub pixels (8 220 800) which require sophisticated technology to produce.However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the 3erformance of theproduct.Installing the StandPreset: Place the Guide Stand and Cover Neck onto the stand and fasten it usingthe screws. Applicable to models (UN32B6000) only.1. Attach your LED TV to the stand.Two or more people should carry the TV.Make sure to distinguish between the front and back of the stand whenattaching it.To make sure the TV is installed on the stand at a proper level, do not applyexcess downward pressure to the upper left of right sides of the TV.2. Fasten screws at position O and then fasten screws at position O.Stand the product up and fasten the screws. If you fasten the screws with theLED TV placed down, it may lean to one side.kDisconnecting the Stand1. Remove screws from the back of the TV.2. Separate the stand from the TV.Two or more people should carry the TV.3. Cover the bottom hole with the cover.