ENGLISH60CheckingTroubleshooting CheckD If you run into any problem using the camcorder, use the following table to try to resolve the problem.D If these instructions do not allow you to solve the problem, take a note of:n The model and serial number marked on the bottom of the camcorder.n Your warranty, if applicable.D Then contact your nearest authorized service centre.Symptom Explanation/SolutionYou cannot switch the u Check the battery pack (see page 19)camcorder on. or the AC power adapter. (see page 18)Start/Stop does not u Check the POWER, set it to CAMERA.operate while shooting. u You have reached the end of the cassette.u Check the record protection tab on the cassette. (see page 22)The camcorder goes u You have left the camcorder set to STANDBYoff automatically. for more than 5 minutes without using it.(see page 24)u The battery pack is fully used up. (see page 21)The battery pack is u The atmospheric temperature is too low. (see page 21)quickly exhausted. u The battery pack has not been charged fully.(see page 19)u The battery pack is completely dead, and cannot be recharged.Use another battery pack.You cannot eject the u The battery pack is fully discharged.cassette from the u A mechanical fault may have occurred. (see page 59)compartment.The DATE/TIME indicator u The lithium battery is not installed or is fully used up.flashes more than 2 times (see page 17)when you set thecamcorder to CAMERA.The playback picture u The video heads might be dirty. (see page 57)is in poor quality.You can do nothing u A mechanical fault may have occurred. (see page 59)with the camcorder.