|
ENGLISH147147Troubleshooting : Self-Diagnosis DisplaySelf-Diagnosis DisplayChecklist✤ Before contacting service personnel, please read and check following table. If the problem continues, contact your nearestSamsung dealer or authorised service centre / personnel.Symptom Possible Causes MeasureNot enough free space for saving files.The paper is not inserted or set improperly.Paper jam or other printing error occurred.Ink is low.USB cable is not connected or set improperly.Battery Power is low.The mini SD card is not inserted or damaged.The mini SD card is not formatted.Failed to write a file.Failed to read a file.The file is protected.Memory Full!Paper Error!Print Error!Ink Error!Connect USB Cable!Low Battery!Card ErrorNot formatted!Write Error!Read Error!Protect!Check the space of internal memory or the external memory.Check the paper in the printer. If there is no paper, insert paper.Check the printer message. Refer to the printer manual for details.Replace ink or toner.Check the USB connection. Disconnect and try to connect again.Charge the Battery Pack or connect the AC Power Adapter.Replace the mini SD card.Format the mini SD card or replace with a formatted one.Check the memory space or format of the mini SD card.Delete the damaged / corrupted file.To delete a protected file, unlock the protection prior to deletion.Informs that… ActionDisplayNo Power is supplied.Date / Time is wrongFocus does not adjust automaticallyThe mini SD card will not load properly.Colour balance of the picture is not natural.Digital zoom does not work.Files stored in the mini SD card can not bedeleted.The power is not connected properly.The battery is dead.The battery is too cold.The Date / Time is not set.Focus mode is set to manual.Recording was done in a too-dark place.Lens is covered with condensation.The mini SD card is inserted improperly.Foreign substances are in the memory slot.White balance setting is not suitable for therecording situation.The digital effect is set enabled.Mini SD card is protected.The file is protected.Connect the AC Power Adapter properly, page 24Replace with a new Battery Pack.Warm up the battery or move it to a warmer place.Set the Date / Time, pages 42Set the focus mode to .Use a strobe or light the place.Clear the lens and check the focus.Insert the mini SD card properly, page 33.Clear the memory slot.Set proper white balance, page 69.Turn off the Digital Effects, page 66.Release the mini SD card protection tab.Unlock the protection of the file, page 84.
|
