Troubleshooting _21INFORMATION CODESInformation codes may be displayed to help you better understand what is occurring with your Washer.CODE SYMBOL MEANING SOLUTIONUnbalanced load prevented yourWasher from spinning.Redistribute the load, press the Start/PauseButton.Door is unlocked when Washer isrunning.Press the Power button to turn off your Washer,then restart the cycle. If the code reappears, callfor service.Door is open when Washer isrunning.Close the door tightly and restart the cycle.If the code reappears, call for service.Your Washer failed to lock thedoor.Close the door tightly and restart the cycle.If the code reappears, call for service.Water temperature controlproblem.(Heater Control problem)Call for service.Your Washer has tried to fill buthas not reached the proper waterlevel.Call for service.The door will not unlock. Make sure the door is firmly closed.Push the Power button to turn off your Washer,then turn it on again. If the code reappears, callfor service.Motor not running properly. Restart the cycle pressing the Start/PauseButton. If the code reappears, call for service.Your washer is not draining.It can also mean that the unitsenses a small clog while draining.Before calling for service, check the following.1) Turn off the unit and turn it on again.2) Select only the Spin Cycle.3) Press the Start/Pause to drain the water.If it still does not drain, call for service.Your Washer has tried to fill butwas unsuccessful.Make sure the water faucets are open all theway. Check for kinked hoses.Check the inlet screens on the fill hoses.Problem with control. Call for service.Electric service was lost whenWasher was running.Restart the cycle by pressing the Start/PauseButton.A fault is detected in the waterlevel sensor.Call for serviceJammed Key. Call for serviceMotor speed sensor problem. Restart the cycle.If the code reappears, call for service.05 TroubleshootingWF218ANB-02240B_EN.indd 21 2008-02-20 ¿ÀÀü 10:31:00