Samsung WF331ANW/XAA User Manual

Also see for WF330AN Series: User manual User manual User manual User manual User manual

Contents

16_ setting up your new washing machine3. Check the inlet hose to ensure a washer is inside each fill hose.Thread the inlet hoses to the HOT and COLD faucetconnections.On the other end of the hose, check for one rubber washer perhose and install each fill hose to the water valve. Make sure thehose with the Hot printed line is attached to the HOT faucet.Tighten by hand until snug, then two-thirds of a turn with pliers.For correct water use, connect both HOT and COLD watervalves. If either or both are not connected, an “nF” (no fill) errorcan occur.4. Turn on the HOT and COLD water supply and check allconnections at the water valve and the faucet for leaks.5. Plug the power cord into a 3-prong, well grounded 120 volt60 Hz approved electrical outlet protected by a 15-ampfuse or comparable circuit breaker.Your washer is grounded through the third prong of thepower cord when plugged into a three-prong groundedreceptacle.6. Slide your washer into position.7. Level your washer by turning the leveling legs in or out asnecessary by hand or by using the wrench included withyour washer.When your washer is level, tighten the locking nuts usingthe wrench or (-) flathead screwdriver.Your washer must be leveled on all four sides. Acarpenter’s level should be used on all four corners ofyour washer. It’s the best to recheck after the first dozenwashes.Avoid damage to the legs. Do not movethe washer unless the locking-nuts arefastened to the bottom of the washer.setting up your washer ColdCold HotHotCold printedCold printed Hot printedHot printedLevellingLevellingLegLegLockingLockingNutNutWF350ANP-02833D-01_EN.indd Sec4:16WF350ANP-02833D-01_EN.indd Sec4:16 2011-10-14 5:00:052011-10-14 5:00:05