Samsung WF431AA User Manual

Contents

12_ Installing your washerinstalling your washer2. Check the inlet hose to ensure a washer is inside each fillhose.Thread the inlet hoses to the HOT and COLD faucetconnections.On the other end of the hose, check for one rubber washerper hose and attach each fill hose to the water valve. Makesure the hose with Hot printed on it is attached to the HOTfaucet. Tighten by hand until snug, then two-thirds of a turnwith pliers.For correct water use, connect both HOT and COLD watervalves. If either or both are not connected, an “nF” (no fill)error can occur.3. Turn on the “HOT” and “COLD “water supply and check thewater valve and the water supply connections for leaks.4. Plug the power cord into a 3-Prong, well grounded 120volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker.Your washer is grounded through the third prong of thepower cord when plugged into a three-prong groundedreceptacle.5. Slide your washer into position.6. Level your washer by turning the leveling legs in or out asnecessary by hand or by using the wrench included withyour washer.When your washer is level, tighten the locking nuts usingthe wrench or (-) flathead screwdriver.Your washer must be leveled on all four sides. Acarpenter’s level should be used on all four corners ofyour washer. We recommend you recheck your washerafter a dozen or so washes to makesure it’s sitll level.Avoid damage to the legs. Do not movethe Washer unless the Locking-nuts arefastened to the bottom of the Washer.Levelling LegLocking NutCold HotCold printed Hot printedRubber WasherWF431ABP-03016A_EN.indd Sec2:12WF431ABP-03016A_EN.indd Sec2:12 2011-01-11 ¿ÀÈÄ 3:17:572011-01-11 ¿ÀÈÄ 3:17:57