58_ Maintaining your washerMaintaining your washerPURE CYCLE TMPure Cycle is a self-cleaning cycle that removes mold that may occur inside the washer.1. Press the Power button.2. Select the Pure Cycle.• Once the Pure Cycle is chosen, the only function that can be set is Delay Start.3. Press the Start/Pause button.• When you press the Start/Pause button, the Pure Cycle begins.• Using the Pure Cycle, you can clean the drum without using a cleaning agent.• Never use the Pure Cycle when laundry is in the washer. It may cause damage to thelaundry or a problem with the washer.• If you want to use a drum cleaning agent, use only 1/10 the amount of the drumcleaning agent recommended by the cleaning agent manufacturer. (When using apowder-type cleaning agent , remove the liquid detergent compartment.)The Pure Cycle Auto Notification• If cleaning the tub (drum) is required, the Pure Cycle auto notifi cation screen appears.When this remove the laundry from the washer, turn the power on, and clean the drumby running the Pure Cycle.• If you do not run the Pure Cycle, the Pure Cycle auto notifi cation screen will be shownagain after two washes. Not running the Pure Cycle at this point will not cause a problemwith the washer.• Although the Pure Cycle auto notifi cation screen appears once a month or so, thefrequency may differ depending on the number of times the washer is used.CAUTIONWF457ARG-03153A-04_EN.indd 58WF457ARG-03153A-04_EN.indd 58 2012-08-31 12:30:352012-08-31 12:30:35
